Update #2: DTC P0191, Fuel Rail Sensor September 24, 2013, 07:19:50 pm Yahoo Message Number: 142872Last Friday the good folks at Barber-Dyson Ford in Elk City, OK, dropped the fuel tank, drained and cleaned it and replaced the fuel pump and fuel pump control module. We were on our by 1030 that morning and, knock on wood, we haven't seen the Check Engine light since in several hundred miles. If I can figure out how, I'll add these folks to the Recommended Shops in the DB. They were definitely very RV friendly, to the point of giving us a hookup out back for the night. Almost to ABQ - we'll be arriving at Kirtland AFB tomorrow, and then joining the LD gang at the Balloon Fiesta on 3 Oct.Safe travels everyone. Ted H. '05 RB @ Santa Rose Lake SP, NM
Re: Update #2: DTC P0191, Fuel Rail Sensor Reply #1 – September 25, 2013, 08:16:01 am Yahoo Message Number: 142873Thanks for the report Ted. Glad to hear that all went well.Do we dare ask how much it cost to that the work done? Let me know if you have any problems adding the recommendation to the DB. Enjoy the balloon festival. We have never been with the LD group, but we used to live in Los Alamos north of ABQ, & went several times. It is quite a spectacle, isn't it?BarryFrom:Last Friday the good folks at Barber-Dyson Ford in Elk City, OK, dropped the fuel tank, drained and cleaned it and replaced the fuel pump and fuel pump control module. We were on our by 1030 that morning and, knock on wood, we haven't seen the Check Engine light since in several hundred miles. If I can figure out how, I'll add these folks to the Recommended Shops in the DB.