Log In | Register
Skip to main content
Topic: Lost Part (Read 212 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.
Lost Part
A few days ago we were cleaning the vent fans in the lounge and BR.  When we were done we found this clip on the floor.  I can’t find where it belongs.   Both fans are working just fine.   Does anyone have an idea about this clip?


Re: Last Part
Reply #2
Best guess, there are plastic clips that snap onto the top of the arms that hold the motor in position, holding the wires in place.  Find the arm with the wires on top and see if it fits there.

Ken F in NM
'08 MB

Re: Last Part
Reply #3
Thanks Ken.  I’ll check tomorrow once we find a place to camp.  (It’s crowded in Utah like so much of this trip).  I’ll probably crawl onto the roof to get a good view of the fan.  At any rate,  I bet you’re right and thanks again. 

Re: Last Part
Reply #4
Holding wires in place was my guess also. I would double check the entire length of the wire that you easily see.
Jane
Jane & Scott
Currently have a 1989 TK  LD we did a lot of upgrades on.
Bigfoot 25RQ Twin on order with early summer 2024 ETA

Our smartphone autocorrects into very poor English.
 We disclaim the illusion of ignorance this creates as we have enough ignorance we rightly claim.

Re: Last Part
Reply #5

Good choice Ken.  https://www.amazon.com/Fan-Tastic-Vent-801250-Roof-1250/dp/B00IKMWQMK    If you look at the picture of an open fan, and cursor over it for the expanded view, you can see that clip holding the wires in.   Unsnapping the fan screen would give you a shot through the fan blade to replace it. Safer than going on the roof.    RonB

As an Amazon Associate Lazy Daze Owners' Group earns from qualifying purchases.
RonB (Bostick) living in San Diego
Original owner of "Bluebelle" a '99 TKB