Gen Turi questions March 05, 2016, 02:35:32 pm Yahoo Message Number: 159182Looking at adding one to my rig..1998 30ft IB, w/gen exhaust between the dr. side window and the kitchen window, mid rig.Problem is, my chrome ex. pipe is 2 1/4 in. at the end--the end being a rolled 'lip' about 1/8 in width, bigger than the 2 ?/?in. inside pipe. Looking at the installation videos, it looks like they are expecting a 'straight' exhaust pipe end, and I don't see a way to adapt mine to their provided bushings, etc.I really don't want to cut the lip off, as I can't do it myself, and would have to take the whole RV somewhere to get it done. Any suggestions on how to adapt what I have to the kit? From the information I see, I have to purchase an additional size part as there isn't one for even a 2in pipe. How will that rolled lip impact the ability of the spacers/bushings to accommodate the mounting of the upright portion?Also, the height of the kit says it's for 10 ft. and I was wondering if other LD owners had added an extension to the top? That's pretty close to barely being above roof top.I have the older Emerald, and was hoping that the claim that it will also help dampen the noise somewhat--anyone have experience with the kit used on the older Emerald?? Gini Free and Junah, canine xtrodinaire "CHERRYOTTE" our litte red home on wheels "Growing old is mandatory. Growing wise is optional."
Re: Gen Turi questions Reply #1 – March 05, 2016, 02:59:07 pm Yahoo Message Number: 159185Thanks for response, What I decided to do is install a 12 volt rear air system into my outside compartment area and tie into my front system. Install my control switches next to my thermostat . Put a 3 way splitter on my central heater vents. I have rear air will traveling down the road. Now in remote areas you have no air, unless you want to carry a portable inexpensive unit.. A.H.
Topic: Gen Turi questions (Read 11 times)
previous topic - next topic
Topic: Gen Turi questions (Read 11 times)
previous topic - next topic