Water supply line replacement January 24, 2021, 12:46:39 am Hi all,The strainer on the water pump is leaking occasionally so I figured I’d replace the water supply lines when I replace the strainer. While I'm at it, I'll install at least one ball valve on the intake side of the water pump per the LD Companion. The Companion article also suggests installing a braided stainless steel supply line from the tank. So I wondered if this setup makes sense: stainless line from tank to valve to strainer, then a second braided line from strainer to pump “in”. Is there a reason why I shouldn’t do it this way?Thanks in advance!Ray & Kari
Re: Water supply line replacement Reply #1 – January 24, 2021, 01:38:34 am Well, the purpose of TWO valves is to isolate the pump at both input and output for mess-free removal. If the pump inlet is higher than the top of your tank, this would be unnecessary, but one might be useful on the output. As far as using stainless braided hose on the low-pressure inlet side, I can see no rationale for that, and it might cause more noise from vibration. I have no idea why it was suggested in the article.Steve
Re: Water supply line replacement Reply #2 – January 24, 2021, 02:56:59 am Consider using a Shurflo Pump Silencing Kit. Amazon.com: SHURFLO 94-591-01 Pump Silencing Kit: AutomotiveThe Shurflo hose has a slight amount of flex that absorbs vibrations and noise, it works fine.Braided hoses do not flex or give much, I prefer a softer line. Water pumps can make a lot of noise, some need all the help they can get.Larry As an Amazon Associate Lazy Daze Owners' Group earns from qualifying purchases.
Topic: Water supply line replacement (Read 128 times)
previous topic - next topic
Topic: Water supply line replacement (Read 128 times)
previous topic - next topic