Log In | Register
Skip to main content
Topic: Corrected URL: Need Help Installing Wave 3 Heater (Read 25 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.
Corrected URL: Need Help Installing Wave 3 Heater
Yahoo Message Number: 159939
Sorry, folks, I goofed on the link to the Wave 3 article in my earlier post.

In our RB, I mounted the Wave 3 at the end of the forward dinette bench on a hinged board that swings out to aim the heater forward when in use.

Here are some pictures.

WxToad Toad Hall The Ultimate Public Campgrounds Project - Home
Quote
Posted by:  ironduckme Date: Sat Apr 16, 2016 9:44 pm ((PDT))

Is there any danger in the heat transfer in a wall mount install? My free standing wave 3 is hot to touch on top and back.

The only other place I can see to wall mount a wave heater in my RB other than the rear wall (where the garbage can is) would be in the under kitchen sink wall on the left side of the entrance steps. Has anyone done that?

Jay Carlson
 
Re: Corrected URL: Re: Need Help Installing Wave 3 Heater
Reply #1 –
Yahoo Message Number: 159958
So it looks like Ted's instal requires a propane line across the floor to run. I T'd into propane by removing the panel on left in the storage area under the refrigerator. I added a T to an existing T (supply to refrigerator I think) and a shutoff valve which I made a small cut out in the paneling to operate. I mounted a connection to a single gang wall plate left of the door to the storage area. I put another shut off valve in the 9' hose to the heater. All done without flaring tools and gas plumbing knowledge, but it did take a lot of time to figure out all the parts needed and get them. Might save yourself a lot of time having a pro RV place to bang it out.

Jay Carlson
Jay Carlson
2003  LD RB
2005 Bigfoot 40MH35LX
rvingjaygwynne.wordpress.com