Log In | Register
Skip to main content
Topic: Squished Step (Read 9 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.
Squished Step
Yahoo Message Number: 147922
I had a run in with a medium sized rock and the house step. The label shows it to be a Kwikee. I checked their website to try to ID it but none of the single non-electric steps are 21 5/8" across. Anyone know if LD used a custom one? This is on a 2006 MB. Thanks. Jim Sadler

Re: Squished Step
Reply #1
Yahoo Message Number: 147923
You might want to call the factory. (909) 627-1219 Art
Art and Barbara
Settled in Atterdag Village of Solvang
2015-2022 fulltime in a 2016 Tiffin Allegro Bus 37AP
2002-2015 2002 LD MB
Art's blog

Re: Squished Step
Reply #2
Yahoo Message Number: 147927
Jim A large percentage of older LDs have smashed and repaired steps.
The manual steps are simple devices and often smashed steps can be repaired with hand tools.
It takes less than five minutes to remove the four nuts securing it to the LD.
A local welding shop would be a good place to get it straightened out, if you need to have it done.

Larry
Larry
2003 23.5' Front Lounge, since new.  Previously 1983 22' Front Lounge.
Tow vehicles  2020 Jeep Wrangler Rubicon, 2001 Jeep Cherokee
Photo Collection: Lazy Daze

Re: Squished Step
Reply #3
Yahoo Message Number: 147929
Hi Jim, We also had an encounter with a curb that was left lying too close to the lane of traffic (:-/). We were pleasantly surprised that it could be fixed. In our case, Erik's RV in Sequim did the job in about 15 mins.
Good luck! Sandy

Re: Squished Step
Reply #4
Yahoo Message Number: 147968
I recently tangled with a 2x6 which bent my electric steps to one side, allowing them to only close part way. A storage unit neighbor had his step repaired at the Camping World collision center. I stopped by to make an appt. and the shop mgr. said it would only take 15 minutes to straighten them. He said let him eat lunch and he'd straighten them. He used a ratcheting device on a metal rod and ratcheted them into shape. 15 minutes later and a minimum charge of $45 and the steps were perfect. Great service!Chris2002 30' IBArvada, CO (Denver)
Formerly: 2002 30' IB

 
Re: Squished Step
Reply #5
Yahoo Message Number: 147981
Thanks all for the suggestions. I'll take it by a welding shop and see if it can be fixed and call LD for pricing info. Thanks again. Jim Sadler