Bolt Torque Question April 18, 2012, 08:27:48 pm Yahoo Message Number: 129965I recently had the drive train disconnected at the rear of the LD tohave it towed. What is the torque setting for these bolts when it'stime to reconnect the rear end again ?Thank youJC
Re: Bolt Torque Question Reply #1 – April 18, 2012, 09:30:10 pm Yahoo Message Number: 129966Quote I recently had the drive train disconnected at the rear of the LD tohave it towed. What is the torque setting for these bolts when it'stime to reconnect the rear end again ? If it was the four bolts that connect the rear u-joint to the flange on the differential, the service manual for my 2002 E-450 lists the torque as 83 ft-lb (112 Nm). I hope whoever removed the driveshaft marked the correct alignment before disconnecting the driveshaft. Not keeping the same alignment could result in a driveshaft balance problem.Art
Topic: Bolt Torque Question (Read 4 times)
previous topic - next topic
Topic: Bolt Torque Question (Read 4 times)
previous topic - next topic