Re: Olympian 57331 Wave 3 Catalytic Safety Heater Reply #25 – December 31, 2016, 06:54:42 pm Kent, I don't know anything about either of these businesses (or just how far they are from you), but it might be worth a call to find out if either or both are qualified to install a Wave.Meyers RV Repair Center Torrance Serving | Los AngelesEXO Mobile RV Service | Mobile RV Repair Westminster
Re: Olympian 57331 Wave 3 Catalytic Safety Heater Reply #26 – December 31, 2016, 07:23:33 pm Harold,Thanks. I've heard and read about the Buddy in the past and had considered it as an alternative to the Wave but ultimately choose the Wave after reading it's reviews.For now I'll take the time to find the tech to do the install of the quick connect and stay with the LD furnace in the meantime.It'll get done. As for now, the Wave 6 will stay tucked away at home. Just another project awaiting its turn. I do like the decadence of your "undercarriage" heating. Big Bear can get a bit nippy in November and a little more heat in the seat is always a good thing.Kent
Re: Olympian 57331 Wave 3 Catalytic Safety Heater Reply #27 – December 31, 2016, 07:32:41 pm Joan,Thank you for the links. I was at Myers a couple of weeks ago. The clerk was very nice and had at one time lived in Long Beach. This is where I snapped the shot of the funky double decker RV.The mobile service seems promising. It would be nice to have the work done at home if possible.I'll give them both a call next week.Thanks again.Kent
Re: Olympian 57331 Wave 3 Catalytic Safety Heater Reply #28 – December 31, 2016, 08:51:17 pm Kent,Our friends with the Wave heater love theirs and I'm sure you will too. What a nice gift from your bride.We'll be in Borrego Springs next weekend (1- 6 and 7) for a Geology lecture and field trip with ABDNA, and then Agua Caliente county Park (1-8 and 9) for hiking and sitting in the hot springs. Got space in your travel schedule to join us?Have a great New Years to you and to all of the Lazy Daze Owners!Harold 1 Likes
Re: Olympian 57331 Wave 3 Catalytic Safety Heater Reply #29 – January 01, 2017, 03:01:16 pm Kent, I did the plumbing myself. I was able to "T" into the gas plumbing under the right side of the oven just left of the refrigerator. I put a disconnect through the wall just to the left of the storage door under the refrigerator. I have a 9 foot hose that allows the heater to be moved around and pointed in different directions. The 9 foot hose is a bit longer than needed, I think 6-7 feet would be enough.When I got the the Wave 6 I got a 3 foot hose and a "T" with more disconnects so I can run both heaters at once. That gets to be a bit of a mess of hoses but doable, but you won't need that part with one heater.
Re: Olympian 57331 Wave 3 Catalytic Safety Heater Reply #30 – January 01, 2017, 07:31:36 pm Jay,Thanks for the input. While I am pretty competent in most projects I do, it generally takes a couple of goes at something to be comfortable with newly acquired skills. Plumbing propane lines for my '15 RB is something that I prefer to have down right the first time (there may not be a second chance to get it right). So I'll defer this project to the professionals.With that, I do appreciate your input and will take your path to heart when I find the right team. Some things just take a little more time to accomplish. Like our LD. It took twenty years to finally get it. I certainly don't want to risk it on my skill set.Kent
Re: Olympian 57331 Wave 3 Catalytic Safety Heater Reply #31 – January 02, 2017, 10:55:09 am Good thinking Kent. As a practiced shade-tree mechanic, I can do lots of repairs and get them right eventually. However, LP gas line repairs and dentistry is best left to the professionals.HD 2 Likes
Re: Olympian 57331 Wave 3 Catalytic Safety Heater Reply #32 – January 03, 2017, 08:49:18 pm I wish I had bought the Wave 6 originally - but I didn't. I have the Wave 3. What I did was have my RV repair person in Las Cruces tap into my propane line and install a quick disconnect. I find that if I close off the "door" in my mid-bath it sufficiently heats either the front or back. The heater has a five or six foot hose and that makes it easy.In my opinion any "experienced" RV tech can tap into your propane line and install your quick disconnect. Another option I've seen is to connect the line to an outside portable tank. You "do" want to have someone knowledgeable do this, but it's not a "super specialized" job. I'm currently in Mexico and in the morning I run the furnace for a short time to "take the chill off" and then if it's a cold morning I run the Wave 3.
Re: Olympian 57331 Wave 3 Catalytic Safety Heater Reply #33 – January 04, 2017, 12:04:45 pm Quote from: Blueox25 - December 31, 2016, 06:45:57 pmI've used one of these for years in various boats with good success:Amazon.com: Mr. Heater F274830 MH18B Big Buddy Grey Indoor-Safe Portable...Mr. Heater has a 7000' altitude limitation, the Waves work fine at 10,000', a consideration if you camp in the Rockies or in the higher areas of the Sierras.To install a Wave, I use a kit from RV Solar Electric.Portable heater hook up kitUsually the propane supply is sourced from behind the stove.The quick disconnect is mounted at floor level, under the stove in most installations.In addition to the kit, do install a gas-rated shut off valve. The quick disconnect is sealed with o-rings that have the potential to wear and leak. It's best to shut the gas supply off when the heater is not in use.In many cases, the Factory propane line needs to be cut and flared, a chore that is best left to experienced personnel.Do check for leaks after installation, using a gas leak detection fluid, a manometer or a electronic leak detectorBrassCraft 2 oz. Gas Leak Detection Solution-PSC1094 L - The Home DepotLarry 1 Likes As an Amazon Associate Lazy Daze Owners' Group earns from qualifying purchases.
Re: Olympian 57331 Wave 3 Catalytic Safety Heater Reply #34 – January 04, 2017, 12:09:29 pm "In my opinion any "experienced" RV tech can tap into your propane line and install your quick disconnect."---I suppose this depends on the amount and level of "experience" of the technician, and how much of that is with propane line and equipment installations. A lashed-up LPG installation, of components, or using the wrong tools (or using them incorrectly, e.g., using only one wrench on a connection and twisting the copper piping, or mis-using a flaring tool) will give a leaky and dangerous result. Overcautious? Perhaps, but overestimating a tech's skill set and/or underestimating the potential results of a poorly done job might really ruin one's day! As ever, YMMV.Joan
Re: Olympian 57331 Wave 3 Catalytic Safety Heater Reply #35 – January 04, 2017, 02:24:45 pm Quote from: Larry Wade - January 04, 2017, 12:04:45 pmIn many cases, the Factory propane line needs to be cut and flared, a chore that is best left to experienced personnel.Do check for leaks after installation, using a gas leak detection fluid, a manometer or a electronic leak detectorBrassCraft 2 oz. Gas Leak Detection Solution-PSC1094 L - The Home DepotLarry While not rocket science, experience is preferred and proper tools are necessary. The leak test, as Larry indicates, is most important. DO NOT RELY ON THE THE SMELL TEST ONLY! I replaced the propane regulator and hoses on my last RV. Did the smell test and nothing. Then did a soap bubble test which indicated a leak, so don't forego this important task! 1 Likes
Re: Olympian 57331 Wave 3 Catalytic Safety Heater Reply #36 – January 04, 2017, 08:40:45 pm I have seen Larry's installation (with the kit from rvsolarelectric.com) and it is a thing of *beauty*. Very elegant, actually, with only the quick-release adapter showing on the outside. Downright minimalist.
Re: Olympian 57331 Wave 3 Catalytic Safety Heater Reply #37 – January 05, 2017, 06:39:45 pm I just made an appointment with Manny at Myers RV in Torrance, Ca to have my propane quick connect installed. Total cost should be around $225.00 For me, cheap at twice the price. Expect 2 1/2 days in the shop and ready to go. When I questioned Manny in regards to his familiarity with LD, I was informed that he regularly services 6 LD's. Very encouraging and he gave every indication of being very professional. I'll keep you posted on my final results.Kent 1 Likes
Re: Olympian 57331 Wave 3 Catalytic Safety Heater Reply #38 – January 06, 2017, 07:03:07 pm Quote from: Kent Heckethorn - January 05, 2017, 06:39:45 pmI just made an appointment with Manny at Myers RV in Torrance, Ca to have my propane quick connect installed. I'll keep you posted on my final results.KentI used Myers for replacement of the start capacitor of the A/C under warranty on our '06 TK years ago. Dometic put them and me through the wringer requiring multiple tests (and repeated visits by me) before they would authorize the repair. I found Myers to be quite competent, but some of their posted services prices I recall being high. Haven't used them since, as no other problems have arisen with the rig (fingers crossed) and I have been lucky to have become a FOL (those in the know will decipher that 😉). -- Jon
Re: Olympian 57331 Wave 3 Catalytic Safety Heater Reply #39 – January 06, 2017, 09:04:12 pm Jon,I had been by Myers for generator oil a while back. They appear knowledgable and your endorsement is encouraging.Thanks Kent
Re: Olympian 57331 Wave 3 Catalytic Safety Heater Reply #40 – January 07, 2017, 10:49:09 am Quote from: Kent Heckethorn - January 05, 2017, 06:39:45 pmI just made an appointment with Manny at Myers RV in Torrance, Ca to have my propane quick connect installed. Total cost should be around $225.00 For me, cheap at twice the price. Expect 2 1/2 days in the shop and ready to go. When I questioned Manny in regards to his familiarity with LD, I was informed that he regularly services 6 LD's. Very encouraging and he gave every indication of being very professional. I'll keep you posted on my final results.KentI'll keep you posted on my final results.Please do, Kent. If you are satisfied, I'll add this facility to the list of recommended repair locations.Chris